Assuming that systems are synchronized, which action could take place if the fail-over cable is connected
correctly and working properly, but the systems cannot communicate over the network due to externalnetwork problems?
Which action will take place when a failover trigger is detected by the active system?
How is MAC masquerading configured?
Assuming there are open connections through an active system’s virtual servers and a fail-over occurs, by
default, what happens to the connections?
Given that VLAN fail-safe is enabled on the external VLAN and the network that the active BIG- IP’s
external VLAN is connected to has failed, which statement is always true about the results?
Assuming other fail-over settings are at their default state, what would occur if the fail-over cable were to be
disconnected for five seconds and then reconnected?
Which two statements describe differences between the active and standby systems? (Choose two.)
When using the setup utility to configure a redundant pair, you are asked to provide a “Failover Peer IP”.
Which address is this?
When upgrading a BIG-IP redundant pair, what happens when one system has been updated but the other