Refer to the exhibit.

Based on the exhibit, what does the difference between the inbound network rate and writes to disk indicate on
the EMC Data Domain system?

Refer to the Exhibit.

On the EMC Data Domain system, what is the approximate amount of data sent to the system on March 2nd?

Refer to the Exhibit.

On the EMC Data Domain system, what is the approximate amount of disk space consumed on November 11?

Refer to the Exhibit.

Between February 27th and March 4th, what is the highest compression factor reached (approximately) on the
EMC Data Domain system?

Refer to the Exhibit.

On the EMC Data Domain system, what is the approximate amount of data sent to the system on November
11th?

Refer to the exhibit.When monitoring the system show performance command output, you notice that the state column has “D” for
each line entry. What does the “D” in the “State” column indicate?

Refer to the exhibit.

When monitoring the system show stats command output, you notice that the “Disk Write KiB/s” column does
not have same data rate as “Net eth0a in MB/s” column. What is a possible reason for this behavior?

Refer to the exhibit

You are installing an EMC Data Domain system with expansion shelves. When is the cable connector shown in
the exhibit used?

Refer to the exhibit.

You are installing an EMC Data Domain system with expansion shelves. When is the cable connector shown in
the exhibit used?

Refer to Exhibit.

An EMC Data Domain customer has three offices with their payroll backups currently located in San Jose,
California. They want to plan a disaster recovery strategy. The customer is concerned with the possibility of
multiple disasters that could compromise both the source and destination sites simultaneously.
Which replication topology will address the customer’s concerns about availability and RTO?