A storage array is configured with four front-end ports on each controller (in a dual-controller configuration) for
server connectivity. The storage array runs in Legacy Port mode. An engineer needs to provide multi-pathed (2
fabrics) connectivity from the storage array to the server.
What is the minimum number of fault domains required?
A customer has iSCSI servers that occasionally perform poorly. The performance issues on a particular server
occur during temporary traffic spikes to that server. Logs show that the number of dropped packets increases
during the traffic spike. In normal traffic conditions, performance is acceptable.
What are iSCSI best practices to fix this problem?
The SAS chain starts in port 1 controller 1 and ends at controller 2 at port 3.
What are the correct connections in a 4-port SAS IO card?
Which two steps should the engineer take prior to racking any equipment? (Choose two.)
The administrator notices that some disks show as down intermittently. The disks are all in the same enclosure.
What is the problem?
A deployment technician needs to install a dual-controller Storage Center with two Fibre Channel (FC) fabrics.
The site will run in Legacy mode.
What is the correct front-end cabling?
An engineer needs to install an LSI9206 SAS card in an existing SC8000 system that runs version 6.1.
Which step should the technician take to install this IO module?
A deployment technician has cabled several enclosures on one chain: (1) SC200, (1) SC220, and (1) SC 280.
When the deployment technician tries to configure the Disk folder, some disks are missing.
What is the cause of this problem?
According to the best practices, what are the correct values for the following parameters on a QLogic HBA?
A customer has mapped a volume to a Windows 2008 server using two 16 Gb FC paths and two 1 Gb iSCSI
paths. The customer needs the traffic to split equally across only the two FC paths without using iSCSI under
normal conditions. If the FC network is down, traffic should failover to the iSCSI paths to maintain connectivity.
Which Windows 2008 multi-pathing policy should be used?