Which method should be used to map a volume to a server in Enterprise Manager?

A customer has multiple Storage Centers at their main site and a DR system at a remote site. A particularly
important volume requires High Availability protection. An outage on one system at the main location must NOT
cause data to be inaccessible. Disaster Recovery protection is also required to protect data even if the entire
main site goes down.Which technology best meets these requirements?

A customer has a newly installed storage array. The customer needs to proactively monitor and report storage
utilization on a regular basis.
Which customizable, proactive tool should be configured to perform this task?

An engineer is configuring fault domains and front-end IO ports on a dual controller storage array. Any volumes
that are later created and mapped to a server must be active/optimized on one controller and standby on the
other controller.
Which port mode should the engineer use to meet this requirement?

A zone must include at least one target and at least one initiator.
How many targets and initiators should each zone include according to recommended best practice?

What are two 1 Gb iSCSI best practices to set up and-to-end connectivity (servers, switch, and storage)?
(Choose two.)

An engineer needs to install an SC8000 with four FC ports in each controller and two FC switches set up in a
dual fabric. Each controller also has two 10 Gb iSCSI ports. All iSCSI ports are connected to an ethernet switch.
The system uses virtual ports.
How many fault domains are required?

A deployment engineer is installing a dual-controller Storage Center with four FC ports in each controller. This
system need to use Legacy Port mode because the AIX version used requires it.
Which two configurations are required to set up the fault domains? (Choose two.)

An engineer has several servers connected to the Storage Center through two FC fabrics. The Storage Center
runs in Virtual Ports mode. The engineer needs to create zones based on World Wide Names (WWN).
Which WWNs from the Storage Center need to be included in the zone with the server WWN?

There are several servers connected to the Storage Center through Fibre Channel (FC) fabrics using WWN
zoning. The engineer has recently replaced a server’s FC HB. This server can no longer connect to the Storage
Center.
What is causing the problem?