What describes the power requirements for Dell EMC PowerStore?
What describes the power requirements for Dell EMC PowerStore? A. Lower model numbered systems require less AC line current than higher model numbered systems B. T models require less total power than X models C. X models require less total power than T models D. Lower model numbered systems require less input voltage (VAC) than […]
What is different about the management network configuration for the new appliance compared to configuring an
A Storage Administrator is adding an appliance into an existing Dell EMC PowerStore T cluster. What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster? A. All the needed management IP addresses for the new appliance must be pre-configured on the cluster B. Additional […]
Through which network do external hosts connect to the cluster for data access?
Through which network do external hosts connect to the cluster for data access? A. Management B. ICM C. ICD D. Storage Reference: https://topics-cdn.dell.com/pdf/pwrstr-hcg_en-us.pdf
What describes Dell EMC PowerStore X front-end cabling?
What describes Dell EMC PowerStore X front-end cabling? A. Uses internal VMware virtual switching and does not require a management network B. Storage and management use the same LACP bonded cable connection C. Uses VLTi data switch interconnectivity to support vMotion networks D. Management and discovery use the same cables and connections as storage
What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell E
What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone? A. N-Series switches can be configured to use LLDP or CDP to communicate configuration information with Cisco devices B. N-Series switches can be configured to use only CDP to communicate […]
When configuring a Dell EMC N-Series switch for voice traffic, which settings are needed?
When configuring a Dell EMC N-Series switch for voice traffic, which settings are needed? A. Enable voice VLAN Set each-interface to LLDP share all VoIP related parameters Set switchport mode to general B. Create a VLAN for voice Set each interface to ISDP share all VoIP related parameters Set switchport mode to general C. Enable […]
If Client B sends a packet to Client A, what is the highest level of the network hierarchy that the packet wil
Refer to the Exhibit. If Client B sends a packet to Client A, what is the highest level of the network hierarchy that the packet will transverse? A. Distribution B. Network C. Access D. Core
What is the recommended maximum number of routers, per area, when using OSPF?
What is the recommended maximum number of routers, per area, when using OSPF? A. 50 B. 100 C. 200 D. 255
What is the IP protocol number, in decimal, assigned by IANA for VRRP?
What is the IP protocol number, in decimal, assigned by IANA for VRRP? A. 25 B. 112 C. 443 D. 1443
Based on this information, what is the Layer 3 QoS value?
After setting up the VoIP configuration, a network administrator issues the following commands with the results shown: console# show voice vlan Administrative Mode………………………Enable console# show voice vlan it gi 1/0/2 Interface………………………………….Gi1/0/2 Voice VLAN Interface Mode……………Enabled Voice VLAN ID………………………….10 Voice VLAN COS Overwrite……………False Voice VLAN DSCP Value……………….46 Voice VLAN Port Status…………………Enabled Voice VLAN Authentication………….…Disabled Based on […]