Your companyinforms you that they are trying to hook a new laptop up to their 802.11g network. Your company says that even though the utility shows that the access point has high signal strength and that there is an excellent connection to the access point, their laptop is unable to get a valid IP address and thus cannot connect to servers on their wired network. Which are the two wireless network problems that can be the reason for this situation? Choose 2

Which of the following is an advantage of using WPA-Personal as a security solution for 802.11a networks, rather than WEP-128?

Which of the following are two statements that best describe 802.11-1999 (R2003) network operation with regard to association and re-association processes? Choose 2

Which two of the following statements pertaining to 802.11-compliant systems and co-located access points are accurate? Choose 2

You are contracted by a local school to wirelessly connect a mobile classroom to the school’s network infrastructure. You are thinking about positioning a wireless workgroup bridge at the mobile classroom to create the wireless connection back to the main building in which the school’s data center is located. What should you take into consideration prior to deploying a wireless workgroup bridge in this scenario?

The use of which four Extensible Authentication Protocol (EAP) types is included in the WPA/WPA2-Enterprise certification programs from the Wi-Fi Alliance? Choose 4

During a site survey, it is important to collect and record data about radio frequency related interference and blockage sources that result in reduced signal coverage. The least amount of RF signal loss is introduced by which type of building construction material?

Which of the following are three items that are specified by or derived from the IEEE 802.11i wireless LAN security amendment? Choose 3

Your companyhas many client devices, some that support WEP, some that support WPA, and some that support WPA2. The client devices that support only WEP can be firmware upgraded to support the TKIP wireless security protocol. As the wireless administrator at Your company, it is your responsibility to provide the strongest industry standard layer-2 security possible while applying a reliable solution for all devices. Which are two security measures that you should apply to meet Your company’s requirements? Choose 2

You are a network engineer for your company. Your company wants you to establish an outdoor WLAN connection between two buildings that are 2 kilometers (1.24 miles) apart. Your first required goal is to create a point-to-point link between the two buildings within FCC regulations. Secondly, you need to provide an industry-standard security solution capable of supporting mutual authentication. Protecting your wireless bridges from environmental elements such as windblown dust, rain, and splashing water could be done as an optional goal.

You proceed by installing an 802.11b wireless bridge at each building, configuring one in root mode and the other in non-root mode. You then configure each radio for 1 watt (+30 dBm) and connect 9 dBi omni-directional antennas to both. You position each wireless bridge in a NEMA- compliant enclosure intended for outdoor use and configure them for 802.11i-compliant security features. Which statement in relation to the solution you chose to deploy is accurate?