DRAG DROP
GigSwitch1 is currently configured with a speed of 100 and Duplex is set to Auto on all interfaces.
Interface 2 will be connected to GigSwitch2 which is used for all departments. Interface 1 will be
used for HR traffic only.
GigSwitch1 needs to be configured with the following parameters:
Configure the necessary protocol to prevent switching loops
Configure GigSwitch1 with a /24 IP address for management
Traffic across Interface 1 needs to be forced to accept and receive up to 100Mbps data at
the same time
Traffic across Interface 2 needs to be forced to use Gigabit speeds and maximum
performance
Drag and drop the appropriate configurations to their corresponding requirements. All placeholders
must be filled. Not all configurations will be used.
Answer: 
Explanation:
took the n010-006 today and 2 questions on aiotesking were on their, nothing else. I studied up I passed…
0
0
did you use dumps to study?
0
0