An network engineer is asked to perform an export of the captured trace output files as requested
by Citrix Tech support. In which directory could the engineer retrieve the captured log files in the
NetScaler system?

A network engineer is testing a new load balancing virtual server “test” that has the service group
“test-grp” bound to it. Which command could the engineer run to show connection details for the
new virtual server?

A network engineer has been tasked with identifying the cause of intermittent network connectivity
issues. Which command should the engineer use to generate the necessary network information
required to diagnose the connectivity issues?

A network engineer wants to collect performance statistics regarding the traffic between different
points in the connection, specifically from client-to-NetScaler and from NetScaler to back-end
server, and be able to present this to different analysis tools. Which feature on the NetScaler could
the engineer use for this?

Scenario: A network engineer has created and bound an UDP-ECV monitor to identify the status
of a UDP service. However, no matter what the response is, the service is always marked as UP.
A possible cause of this behavior is that the network engineer ____. (Choose the correct option to
complete the sentence.)

A network engineer should use the Advanced tab when configuring load balancing to enable ____.
(Choose the correct option to answer the question.)

Scenario: A network engineer has created an SSL offload virtual server. The virtual server shows

as a DOWN state. Which two scenarios could cause the virtual server showing as DOWN? (Choose
two.)

Scenario: An engineer needs to configure a monitor to ensure that each server is tested every 10
seconds and requires that the server pass the test four consecutive times before marking a server
as UP. If the test fails, the server should be marked as down for 60 seconds. To configure the
monitor, the engineer should configure an interval of 10 seconds, down- time of 60 seconds; ____
as 4; and retries as ____. (Choose the correct set of options to complete the sentence.)

A network engineer is troubleshooting a situation where ARP requests for IPs in other subnets (for
example 10.192.12.80) are appearing in the 10.192.8.0/24 subnet. Which command could the
engineer run on the NetScaler to verify IP to VLAN bindings?

Scenario: A network engineer has configured an HTTP application to be load balanced using a
virtual server named Svr1. Users have reported intermittent errors and the engineer has been given
the client IP address of an affected user and asked to determine which back end service they are
connected to. Using the command-line interface, how could the engineer find this information?