Scenario: An application that uses HTTP for connections and other protocols for different types of
content has been deployed. Load balancing virtual servers have been created for each protocol
and the engineer now needs to ensure that once a load balancing decision has occurred, further
requests for different content are served from the same server. How could the engineer achieve
this?

Scenario: A company has three HTTP servers that are load balanced using NetScaler. When users
connect to the HTTP application they often receive inconsistent data or are advised that they need
to log on again. Which step should the engineer take to correct this?

A network engineer wants to configure a NetScaler for load balancing Voice over IP traffic (VoIP).
Which hash method is the best fit for VoIP traffic?

Company policy states that all passwords should travel the network in encrypted packets except
SNMP. Which command should the network engineer execute to comply with this policy?

Which type of authentication server could an engineer configure in order to provide the use of RSA
token authentication as a permitted authentication method to access a AAA Virtual Server?

A security test has been completed on an SSL offload implementation and it has been determined
that the certificate key length is too short and must be increased. Which two steps must the network
engineer complete to resolve this? (Choose two.)

Scenario: A network engineer configured a new NetScaler MPX appliance without any VLANs and
with a single interface connected to the network. The engineer has not completed any other
configurations. The interface is then accidentally disabled and contact is lost with the appliance.
Which two actions can the network engineer take to restore communications to the appliance?

(Choose two.)

When configuring an advanced HTTP callout based on attributes, what are two valid parameters?
(Choose two.)

Scenario: The NetScaler has been connected to two external networks provided by different
Internet Service Providers (ISPs). Dynamic routing is not enabled. Traffic is expected to use the
first ISP (through the 10.50.1.1 router) if possible and the second, slower ISP (through the 10.51.1.1
router) only if the Primary ISP fails. Which two commands could the network engineer execute to
configure the routes? (Choose two.)

Which two compression actions could a NetScaler engineer use? (Choose two.)