Get 50% Discount on All Your Purchases at PrepAway.com - Latest Exam Questions This is ONE TIME OFFER 50% Enter your email address to receive your 50% off dicount code: A confirmation link will be sent to this email address to verify your login. GET YOUR DISCOUNT CODE * We value your privacy. We will not rent or sell your email address.
50% Enter your email address to receive your 50% off dicount code: A confirmation link will be sent to this email address to verify your login. GET YOUR DISCOUNT CODE * We value your privacy. We will not rent or sell your email address.
SPECIAL OFFER: GET 50% OFF 50% Use Discount Code: BRIEF50 A confirmation link was sent to your e-mail. Please check your mailbox for a message from support@prepaway.com and follow the directions. Shop Now
50% Use Discount Code: BRIEF50 A confirmation link was sent to your e-mail. Please check your mailbox for a message from support@prepaway.com and follow the directions. Shop Now
Which two are configuration elements selected during initial setup of the Cisco Nexus 7000 Series Switches? seenagapeMay 21, 2013 Which two are configuration elements selected during initial setup of the Cisco Nexus 7000 SeriesSwitches? (Choose two.) A.Telnet bits B.SNMPv3 community strings C.VDC mode D.Default interface layer E.Default interface state F.CoPP Show Answer
designer says: June 3, 2015 at 12:53 pm Step 18 Specify a default interface layer (L2 or L3). Configure default interface layer (L3/L2) [L3]: interface_layer Step 19 Enter the default switchport interface state (shutdown or no shutdown). A shutdown interface is in an administratively down state. Configure default switchport interface state (shut/noshut) [shut]: default_state http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_0/nx-os/fundamentals/configuration/guide2/fun_nx-os_book/fun_2setup.html 0 0
Step 18 Specify a default interface layer (L2 or L3).
Configure default interface layer (L3/L2) [L3]: interface_layer
Step 19 Enter the default switchport interface state (shutdown or no shutdown). A shutdown interface is in an administratively down state.
Configure default switchport interface state (shut/noshut) [shut]: default_state
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_0/nx-os/fundamentals/configuration/guide2/fun_nx-os_book/fun_2setup.html
0
0