which type of LSAs should you expect to see within the different OSPF area types?
When verifying the OSPF link state database, which type of LSAs should you expect to see within the different OSPF area types? (Choose three.) Select 3 response(s).
Which two options are valid checks that should be performed first to verify proper OSPF operation?
You are troubleshooting an OSPF problem where external routes are not showing up in the OSPF database.
Which two options are valid checks that should be performed first to verify proper OSPF operation? (Choose two.)
Select 2 response(s).
which three factors?
The maximum number of routers per OSPF area typically depends on which three factors? (Choose three.)
Select 3 response(s).
which implementation can help a router not have memory resource issues?
When an OSPF design is planned, which implementation can help a router not have memory resource issues?
Select the best response.
What could be the cause of this problem?
You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router 172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds.
What could be the cause of this problem?
Select the best response.
What could be the cause of this problem?
You have just completed an OSPF implementation. While executing your verification plan, you determine that R1 is not able to establish full OSPF adjacency with R2. The show ip ospf neighbor command output on R1 shows that R2 is stuck in the INIT state.
What could be the cause of this problem?
Select the best response.
Which statement is true about OSPF Network LSAs?
Which statement is true about OSPF Network LSAs?
Select the best response.
which statement describes the configuration of OSPF areas?
When implementing OSPFv3, which statement describes the configuration of OSPF areas? Select the best response.
which statement is correct regarding the redistribution of routes from other routing protocols into OSPF?
By default, which statement is correct regarding the redistribution of routes from other routing protocols into OSPF?
Select the best response.
how can the address 2031:0000:240F:0000:0000:09C0:123A:121B be rewritten?
Using the rules for IPv6 addressing, how can the address 2031:0000:240F:0000:0000:09C0:123A:121B be rewritten? Select the best response.