Which two of these changes are necessary for SwitchA to meet the requirements?
Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.
Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)
What are two valid reasons for adopting IPv6 over IPv4?
The network administrator has been asked to give reasons for moving from IPv4 to IPv6. What are two valid reasons for adopting IPv6 over IPv4?(choose two)
Which statement explains the reason for it?
A network administrator receives an error message while trying to configure the Ethernet interface of a router with IP address 10.24.24.24/29.
Which statement explains the reason for it?
What is the issue for this problem?
The network administrator normally establishes a Telnet session with the switch from host A. The administrator’s attempt to establish a connect via Telnet to the switch from host B fails, but pings from host B to other two hosts are successful. What is the issue for this problem?
Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and waste
The network administrator is asked to configure 113 point-to-point links.Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?
Which command helps a network administrator to manage memory by displaying flash memory and NVRAM utilization?
Which command helps a network administrator to manage memory by displaying flash memory and NVRAM utilization?
which output value indicates to the local router that traffic sent to the corporate site is experiencing conge
Users have been complaining that their Frame Relay connection to the corporate site is very slow. The network administrator suspects that the link is overloaded. Based on the partial output of the Router# show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent to the corporate site is experiencing congestion?
What command will display the required information?
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?
What is one reason that WPA encryption is preferred over WEP?
What is one reason that WPA encryption is preferred over WEP?
What is the highest layer of the protocol stack that the nework administrator is using for this operation?
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the nework administrator is using for this operation?