Which statement about a non-zero value for the load metric (k2) for EIGRP is true?
Which statement about a non-zero value for the load metric (k2) for EIGRP is true? Select the best response.
Which dynamic routing protocol should be deployed in your network to best meet these requirements?
Based on the need to limit processing and bandwidth utilization due to dynamic routing protocol operation, the following routing requirements have been specified for your network.
– partial and incremental routing updates
– only the devices affected by a topology change perform route recomputation
– route recomputation only occurs for routes that were affected Which dynamic routing protocol should be deployed in your network to best meet these requirements?
Select the best response.
Which condition must be satisfied before an EIGRP neighbor can be considered a feasible successor?
Which condition must be satisfied before an EIGRP neighbor can be considered a feasible successor?
Select the best response.
Which routers should you verify first to ensure that the configurations are correct for generating type 3 LSAs
You are developing a verification plan for an upcoming OSPF implementation. Part of this plan is to verify the status of type 3 LSAs within the network. Which routers should you verify first to ensure that the configurations are correct for generating type 3 LSAs?
Select the best response.
which is an important item to check on the two transit OSPF routers?
When verifying OSPF virtual link problems, which is an important item to check on the two transit OSPF routers?
Select the best response.
which type of LSAs should you expect to see within the different OSPF area types?
When verifying the OSPF link state database, which type of LSAs should you expect to see within the different OSPF area types? (Choose three.) Select 3 response(s).
Which two options are valid checks that should be performed first to verify proper OSPF operation?
You are troubleshooting an OSPF problem where external routes are not showing up in the OSPF database.
Which two options are valid checks that should be performed first to verify proper OSPF operation? (Choose two.)
Select 2 response(s).
which three factors?
The maximum number of routers per OSPF area typically depends on which three factors? (Choose three.)
Select 3 response(s).
which implementation can help a router not have memory resource issues?
When an OSPF design is planned, which implementation can help a router not have memory resource issues?
Select the best response.
What could be the cause of this problem?
You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router 172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds.
What could be the cause of this problem?
Select the best response.