During a redistribution of routes from OSPF into EIGRP, an administrator notices that none
of the OSPF routes are showing in EIGRP. What are two possible causes? (Choose two.)

According to RFC 2328, what is the stateful order in which an OSPF router transitions to a
full adjacency with a neighbor router?

If a metric is not specified for routes that are redistributed into OSPF, the default metric that
is assigned to the routes is 20, except for redistributed BGP routes. What is the metric that
is assigned to redistributed BGP routes?
Select the best response.

Refer to the exhibit. Which statement is true aboutthe 6.6.6.0/24 prefix? Select the best
response.

Refer to the exhibit. Based on the output from the show command on RT1which statement
is true? Select the best response.
RT1#show ipv6 ospf interface
FastEthernet0/0 is up, line protocol is up
Link Local Address FE80::218:B9FF:FE12:2CD1, Interface ID 4
Area 0, Process ID 1, Instance ID 0, Router ID 10.1.1.1
Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State Drother, Priority 1
Designated Router (ID) 10.1.3.1, local address
FE80::218:B9FF:FECD:BEF0
Backup Designated router (ID) 10.1.2.1, Local address
FE80::218:B9FF:FE92:28D8
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello is due in 00:00:04
Index 1/3/3, flood queue length 0
Next 0x0(0)/0x0(0)/0x0(0)
Last flood scan length is 2, maximum is 2
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 2, Adjacent neighbor count is 2
Adjacent with neighbor 10.1.3.1 (Designated Router)
Adjacent with neighbor 10.1.2.1 (Backup Designated
Router)
Suppress hello from 0 neighbor(s)

Refer to the exhibit. Which interoperability technique implemented on the dual-stack routers
would allow connectivity between IPv6 sites across automatic created tunnels using the
2002::/16 prefix? Select the best response.

Refer to the exhibit. EIGRP has been configured on all routers in the network. The
command metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the
delay metric is used in the path calculations.
Which router will R1 select as the successor and feasible successor for Network A? Select
the best response.

Which statement is true about the command ipv6 ospf 1 area 0? Select the best
response.

In IPv6, the interfaces running OSPF can be configured with multiple address prefixes.
Which statement is true about the IPv6 addresses that can be included into the OSPF
process? Select the best response.

What does the command clear ipv6 ospf process accomplish? Select the best response.