Routers R1 and R2 are configured for HSRP as shown below:

Router R1:
interface ethernet 0
ip address 20.6.2.1 255.255.255.0
standby 35 ip 20.6.2.21
standby 35 priority 100
interface ethernet 1
ip address 20.6.1.1.2 255.255.255.0
standby 34 ip 20.6.1.21

Router R2:
interface ethernet 0
ip address 20.6.2.2 255.255.255.0
standby 35 ip 20.6.2.21
interface ethernet 1
ip address 20.6.1.1.1 255.255.255.0
standby 34 ip 20.6.1.21
standby 34 priority 100

You have configured the routers R1 & R2 with HSRP. While debugging router R2 you notice very frequent HSRP group state transitions. What is the most likely cause of this?

Which three of the following network features are methods used to achieve high availability? (Choose three)

Which statement best describes Cisco supervisor engine redundancy using Stateful Switchover?

You want to allow Router R1 to immediately become the active router if its priority is highest than the active router fails. What command would you use if you wanted to configure this?

What three tasks must a network administrator perform to properly configure Hot Standby Routing Protocol (HSRP)? (Choose three)

Which three statements are true of a default HSRP configuration? (Choose three.)

Which three protocols have been developed for IP routing redundancy to protect against first-hop router failure? (Choose three.)

Which two statements about the HSRP priority are true? (Choose two)

Regarding high availability, with the MAC address 0000.0c07.ac03, what does the "03" represent?

In the hardware address 0000.0c07.ac0a, what does 07.ac represent?