What is the result of these commands?
A network administrator enters the following switch commands:
Switch(config)#interface range fa0/0-5
Switch(config-if-range)#switchport access vlan 2
What is the result of these commands?
Which statement describes Virtual Router Redundancy Protocol (VRRP)?
Which statement describes Virtual Router Redundancy Protocol (VRRP)?
which two security statement are true?
The show port-security interface fa0/1 command was issued on switch SW1. Given the
output that was generated, which two security statement are true? (Choose two.)
Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the CRC value?
Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the
CRC value?
What three tasks will a network administrator perform to successfully configure Hot Standby Routing Protocol (
What three tasks will a network administrator perform to successfully configure Hot Standby
Routing Protocol (HSRP)? (Choose three.)
what will happen?
When a VLAN port configured as a trunk receives an untagged frame, what will happen?
which statement is correct when an IEEE 802.1Q trunk port receives an untagged frame?
By default, which statement is correct when an IEEE 802.1Q trunk port receives an
untagged frame?
What is the method used to filter traffic being bridged within a VLAN?
What is the method used to filter traffic being bridged within a VLAN?
Which three protocols have been developed for IP routing redundancy to protect against first-hop router failur
Which three protocols have been developed for IP routing redundancy to protect against
first-hop router failure? (Choose three.)
What is a characteristic of a VLAN map that does not contain a match clause?
What is a characteristic of a VLAN map that does not contain a match clause?