All interfaces are active. DSW2 has not become the active device for the VLAN 103 HSRP group. As related to
the VLAN 103 HSRP group, what can be done to make the group function properly?

During routine maintenance, it became necessary to shut down the GigabitEthernet1/0/1 interface on DSW 1
and DSW2. All other interfaces were up. During thistime, DSW1 became the active router for the VLAN 104
HSRP group. As related to the VLAN 104 HSRP group, what can to be done to make the group function
properly?

What is the priority value of the VLAN 105 HSRP group on DSW2?

If GigabitEthernet1/0/1 on DSW2 is shut down, what will be the resulting priority value of the VLAN 1015 HSRP
group on router DSW2?

Which port state is interface Fa0/2 of switch SW-B in for VLAN1 and 175?

Which Spanning Tree Protocol has been implemented on switch SW-B?

Which bridge ID belongs to switch SW-A?

Which port role has interface Fa0/2 of switch SW-A adopted for VLAN 44?

MLS and EIGRP Sim 2
You have been tasked with configuring multilayer SwitchC, which has a partial configuration and has been
attached to RouterC as shown in the topology diagram.
You need to configure SwitchC so that Hosts H1 and H2 can successful ping the server S1. Also SwitchC
needs to be able to ping server S1.
Due to administrative restrictions and requirementsyou should not add/delete vlans, changes VLAN port
assignments or create trunk links
Company policies forbid the use of static or default routing All routes must be learned via EIGRP 65010 routing
protocol.
You do not have access to RouteC, RouterC is correctly configured. No trunking has been configured on
RouterC.
Routed interfaces should use the lowest host on a subnet when possible. The following subnets are available to
implement this solution:
· 172.16.1.0/24
· 192.168.3.32/27
· 192.168.3.64/27
Hosts H1 and H2 are configured with the correct IP address and default gateway.
SwitchC uses Cisco as the enable password.
Routing must only be enabled for the specific subnets shown in the diagram.

Host1

Host 2

STP Lab Sim

The information of the question
You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20. Also, all VLAN and
VTP configurations are to be completed in global configuration mode as VLAN database mode is being
deprecated by Cisco. You are required to accomplishthe following tasks:
1. Ensure the switch does not participate in VTP but forwards VTP advertisements received on trunk ports.
2. Ensure all non-trunking interfaces (Fa0/1 to Fa0/24) transition immediately to the forwarding stateof
Spanning-Tree.
3. Ensure all FastEthernet interfaces are in a permanent non-trunking mode.
4. Place FastEthernet interfaces 0/12 through 0/24 in VLAN 20