During routine maintenance, GigabitEthernet1/0/1 onDSW1 was shut down. All other interfaces were up.
DSW2 became the active HSRP device for VLAN 101 as desired. However, after GigabitEthernet1/0/1 on
DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be
done to make the group for VLAN 101 function properly?

Drag the questions that you would ask the network administrator before you start the planning from theleft to
the night. Not all questions will be used.

Drag the choices on the left to the boxes on the right that should be included when creating a Vlan-based
implementation plan.

Drag the feature descriptions on the left to the respective SNMP versions on the right.

Drag items from panel “Select from these” to panel “Place here”.

Organize the levels by dragging each name from the left to the right.
Put the highest level at the top and lowest at the bottom.

Prioritize the traffic types by dragging them from the left to the appropriate Cisco priority level onthe right. Put
the highest priority at the top and lowest priorityat the bottom.

Place the DTP mode with its correct description.

Drag the items to the proper locations.

During routine maintenance, it became necessary to shut down the GigabitEthernet1/0/1 interface on DSW 1.
All other interfaces were up. During this time DSW1remained the active device for the VLAN 102 HSRP group.
You have determined that there is an issue with thedecrement value in the track command for the VLAN 102
HSRP group. What need to be done to make the group function properly?