What need to be done to make the group for Vlan101 function properly?
During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly?
A. Enable preempt on DS1s Vlan101 HSRP group
B. Disable preempt on DS1s Vlan101 HSRP group
C. Decrease DS1s priority value for Vlan101 HSRP group to a value that is less than priority value configured on DS2s HSRP group for Vlan101
D. Decrease the decrement in the track command for DS1s Vlan 101 HSRP group to a value less than the value in the track command for DS2s Vlan 101 HSRP group.
Which statement is true about the Forward Information Base (FIB) table?
Which statement is true about the Forward Information Base (FIB) table? Select the best response.
Which two statements are true about recommended practices in VLAN design?
Which two statements are true about recommended practices in VLAN design? (Choose two.)
Select 2 response(s).
Which statement is true about 802.1x port-based authentication?
Which statement is true about 802.1x port-based authentication? Select the best response.
What is the effect of configuring the following command on a switch?
What is the effect of configuring the following command on a switch? Switch(config) # spanning-tree portfast bpdufilter default Select the best response.
Which two statements are true about a switched virtual interface (SVI)?
Which two statements are true about a switched virtual interface (SVI)? (Choose two.) Select 2 response(s).
Which set of statements about Spanning Tree Protocol default timers is true?
Which set of statements about Spanning Tree Protocol default timers is true? Select the best response.
Which command will need to be added to External_A to ensure that it will take over if serial 0/0 on External_B
Which command will need to be added to External_A to ensure that it will take over if serial 0/0 on External_B fails?
Select the best response.
which interface command is used to convert a Layer 3 interface to a Layer 2 interface?
On a multilayer Catalyst switch, which interface command is used to convert a Layer 3 interface to a Layer 2 interface?
Select the best response.
Which statement is correct about 802.1Q trunking?
Which statement is correct about 802.1Q trunking?
Select the best response.