An engineer is surveying a customer site for additional wireless coverage. What two menus will an
engineer navigate to in order to determine the maximum number of supported APs? (Choose two.)

An engineer is performing a data collection to validate wireless coverage. At what two locations
should a linear point collection be performed? (Choose two.)

An engineer has WLC redundancy included in WLAN design documentation, where the WLCs are
loaded to half the license capacity therefore allowing half the WLCs to fail without an AP going
offline at a given time. What redundancy model does this describe?

During RF verification, some 5 GHz clients are unable to connect to certain APs, while other 5 GHz
clients can connect to all APs. What may prevent some clients from connecting?

What two tools can an engineer use to verify RF data rates and coverage after installation? (Choose
two.)

How many location points are needed to validate both 802.11b/g and 802.11a in the Cisco WCS
Calibration?

An engineer notes that some areas of a floor fail when using the Location Readiness Tool in Cisco
WCS. What criteria must be met for a point to be considered location ready?

An engineer would like to calibrate the RF environment to improve accuracy. What wireless attribute
is added to the floor‐level calculation by calibrating the floor?

What is the minimum CCX version necessary on a client when adding data points during WCS
Calibration?

What are two advantages of conducting an active survey versus a passive survey when verifying RF
coverage? (Choose two.)