A network engineer acquired a floor plan of a building, temporarily mounted an 1132 AP, associated
a wireless NIC to the AP, and began documenting packet exchanges between the AP and the wireless
NIC while walking throughout the facility. What best describes what the engineer was doing?

An engineer is conducting a VoWLAN survey for voice clients with a max power of 40 mW. What
power level should the engineer set the AP to during the survey?

The customer site requires Cisco 1400 bridges with 28dBi external antennas in a PTP design. What is
the maximum power setting allowed by Cisco?

Refer to the exhibit. A company requires a multi‐point bridge solution with Cisco 1400 series bridges.
The central bridge (B1) is set to 10 dBm, the manufacturing remote bridge (B2) is set to 20 dBm, the
inventory remote bridge (B3) is set to 20 dBm, and the shop remote bridge (B4) is set to 10 dBm.
What is the maximum allowed power setting for all four bridges?

An engineer is conducting a survey for a point‐to‐point link with a 30 dBm transmitter and 6 dBi
antenna over 2.4 GHz. If the engineer reduces the transmitter power to 28 dBm, what is the
maximum antenna gain that can be used?

While performing an active mesh survey with a Cisco 1550 Access Point, the status LED turns solid
red. What does this indicate?

An engineer is performing a site survey for a 5 GHz mesh wireless network. The customer requires
300 Mbps data rates per radio, 2×3 MIMO technology, and legacy beamforming. What Cisco access
point should be recommended?

An engineer installed a 1252 AP and is getting power from the switch. However, devices connected
to the wireless network cannot get 802.11n data rates. What supported switchport protocol or
standard could be the reason for this?

An engineer is deploying an outdoor Mesh network. What are the four major factors that should be
considered? (Choose four.)

An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP
licenses that can be supported?