DRAG DROP
Drag from the left the preferred parameters without excess for location service survey and deployment, and drop them on the right.

DRAG DROP
Drag from the left the devices that would be considered highly mobile or nomadic, and drop them under the appropriate category on the right.

DRAG DROP
Drag from the left the relative AP densities for data, voice, and location services, and drop them under the appropriate categories on the right.

DRAG DROP
Drag from the left the Cisco recommended design limits for hop count and ratio of MAP to RAP when designing an indoor mesh network for voice and data, and drop them on to the appropriate category on the right.

Which choice best describes RF challenges for outdoor mesh site survey and deployment?

When performing a post-installation audit using the Ekahau Survey tool, which four steps are
associated with the passive portion of the audit? (Choose four.)

When designing a WLAN, AP placement is important. How would you rank the density of APs
needed to support location services versus data and voice services?

When designing for location services, how many APs should be heard by each location-ready AP
and at what dBm signal level? (Choose two.)

A Cisco 1250 AP is deployed for a/b/g/n using version 7.0 software on 802.3af PoE. What are the
three deployment results of the 5 GHz radio on channel size, spatial stream, and data rate?
(Choose three.)

Refer to the exhibit.

What is the most likely cause of MAP1 association to MAP2 instead of directly to the RAP?