Which additional configuration steps are required for a zone-based policy firewall to operate in a
VRF scenario?

You are troubleshooting an IPsec VPN problem. During debugging of IPsec operations, you see
the message “attributes not acceptable” on the IKE responder after issuing the debug crypto
isakmp command. Which step should you take next?

Which state is a Cisco IOS IPS signature in if it does not take an appropriate associated action
even if it has been successfully compiled?

Which CLI command would you use to verify installed SSL VPN licensing on a Cisco 1900, 2900,
or 3900 Series ISR?

Which statement is correct regarding GRE tunnel endpoints when you are configuring GRE over
IPsec?

Refer to the exhibit.

Which of these is correct regarding the configuration parameters shown?

Refer to the exhibit.

When you are using dynamic IPsec VTI tunnels, what can you determine about virtual-access
interfaces from the output shown?

Refer to the exhibit.

Based on the partial configuration shown, which additional configuration parameter is needed
under the GET VPN group member GDOI configuration?

CORRECT TEXT
To access the router console port, refer to the Exhibit, click the router for access and perform the following tasks.

When you are configuring a hub-and-spoke DMVPN network, which tunnel mode should you use
for the spoke router configuration?