DRAG DROP
Drag the proper commands in the proper order to configure EBGP as the CE to PE routing
protocol for VPN RED on a PE router.

Refer to the exhibit. A router connected to an MPLS-enabled ATM switch via an LC-ATM MPLS
interface, and a partial configuration for the MPLS-enabled ATM switch and the router are shown.
Which statement describes what is incorrect about the configurations shown?
Exhibit:

An OSPF LSA type 1 route is redistributed into MP-BGP. That same route is then redistributed
back from MPBGP into OSPF on another PE router. In this case, which LSA type on the
destination CE router will the OSPF route appear as?

When using the redistribute ospf {process-id} command, which types of OSPF routes will be
redistributed into BGP?

DRAG DROP
Drag and drop the proper commands in the proper order to create a MP-BGP session between
two PE routers that will be used to support the RED VPN.

Refer to the exhibit. It shows an MPLS network with four routers as well as two customer routers.
Router E is advertising the network 192.168.12.0/24. Rather than propagating the 192.168.12.0/24
network, Router D aggregates the 192.168.12.0/24 route into 192.16.0.0/16. Which route or routes
will Router B receive? Exhibit:

Refer to the exhibit. The MPLS VPN Customer A is using a separate interface for Internet access.
However, with the current configurations shown, the CE router is not receiving any Internet routes
from the PE router. Which two additional configuration commands can resolve the Internet
connectivity issue? (Choose two.)
Exhibit:

Refer to the exhibit. The customer is experiencing routing problems because both sites are using
an AS
number of 65001. As the ISP, which neighbor command would you use to address this issue and
on which two routers would you configure that command? (Choose three.)
Exhibit:

A CE router running EBGP with the MPLS VPN service provider’s PE router is not able to receive
any BGP updates from the PE router, and the debug ip bgp updates on the CE router shows the
following debug message. BGP(0): 150.1.11.18 rcv UPDATE about 150.1.12.16/28 — DENIED
due to: AS-PATH contains our own AS What can be configured on the PE router to solve this
problem?

Which two of the following statements correctly describe the difference between Edge LSRs and
LSRs?

(Choose two.)