At what step do you restart the troubleshooting process if after observing the result of your
troubleshooting, the problem still exists?

Refer to Exhibit.

Which Cisco Unified Communications Manager Real-Time Monitoring Tool component can be
used to view DHCP requests and responses from a Cisco Unified Communications Manager
DHCP server?

Refer to Exhibits.

When the remote destination of IP phone 3001 places an inbound PSTN call to extension 3002,
the caller ID that is displayed on extension 3002 is 7700990255 of 3001. Which course of action
can resolve this issue?

Refer to Exhibit.

Assume that all learned SAF routes are placed in the SAF_Pt partition.
The 3XXXdirectory number pattern is being advertised by a remote cluster and is also being
blocked by the local cluster that is shown in the exhibit. An IP Phone is attached to the local
cluster and is configured with a CSS that contains the following partitions: SAF_Pt and internal_Pt
in this order. When the IP phone places a call to 3001, what will occur?

Refer to Exhibit.

When the user tried to configure the command maximum session 5 under the dspfarm profile 1,
the error shown in the exhibit was reported. Which course of action will resolve this issue?

Refer to the Exhibit.

The Exhibit shows the output of an unsuccessful RSVP call setup that uses G.711 codec. Which
configuration on serial 0/1/0.121 would resolve that issue?

You have been presented with a trouble ticket from an end user who works at a remote location
that is served by a Cisco Unified Communications Manager Express. The user reports being
unable to place calls to international numbers, but all other calls work properly and other users at
this location can place international calls. Which two troubleshooting techniques would be helpful
in resolving this issue? (Choose Two)

Which statement indicates something that can cause an inbound PSTN call to an H.323 gateway
that is configured in Cisco Unified Communications Manager to fail to ring an IP Phone?

Refer to the exhibit.

An IP phone that is connected through a Cisco Catalyst 3750 Series Switch is failing to register
with Cisco Unified Communications Manager. When the user presses the settings button on the
phone, the Operational VLAN ID shows a blank entry. What is the most likely cause for this issue?

If after observing the results of your action plan, the problem still remains, at what point should you
restart the troubleshooting process?