Refer to the exhibits.

The HQ_MRG that is shown in the exhibit is assigned to an MRGL, which is configured at the HQ phones. A call exists between two HQ phones that use G.711 codec. When one of the HQ users attempts to conference a BR phone across the WAN, the conference fails. The SDI trace shows an error “No transcoder device configured.” Which statement indicates the correct resolution or reason for the issue?

Which issue would cause an MGCP gateway to fail to register with Cisco Unified Communications Manager?

Assume a centralized Cisco Unified Communications Manager topology with the headquarters at RTP and remote located at the UK. All route patterns are assigned a route list that contains a route group pointing to the local gateway. RTP route patterns use the RTP gateway, and UK. Route patterns use the UK gateway. When a UK user logs into an RTP phone using the Cisco Extension Mobility feature and places an emergency call to 0000, which statement about the emergency call is true?

Which of these is used by the the Ciso IP phone to relay to the switch the information regarding how much power is needed?

Refer to the exhibit.

The exhibit shows the output of debug isdn q931. An inbound PSTN call was recieved by an MGCP gateway that is registered with a Cisco Unified Communications Manager. The call failed to ring extension 3001. If the phone at extension 3001 is registered and reachable through the gateway inbound CSS, which two actions can resolve this issue? (Choose two)

Which step in the problem-solving model is important to accurately interview end users to get all the pertinent details of the problem?

An IP phone that is connected through a Cisco Catalyst 3750 Series Switch is failing to register with the subscriber as a backup server. When the user presses the settings button in the phone, only the Cisco Unified Connunications Manager publisher shows as registered. What is the most likely cause for this issue?

Refer to the exhibits.










MOH has been configured to run from flash at the BR1 site. The HQ Phones and MOH server are placed in the Default region through the Default device pool. The BR1 phones are placed in the BR1 region through the BR1 device pool. The region configuration between Default and BR1 only permits G.729 codec.

When an IP phone user at the HQ site places a BR1 caller on hold, the BR1 caller hears tone on hold. Which of the following can cause this issue?

Which Cisco Unified Communications Manager troubleshooting tool can be used to look at detialed specific events, such as dial plan digit analysis, as they are happening?

Refer to the exhibit.

When calling 911, which gateway/route list is defined in the route pattern in Cisco Unified Communications Manager and used to route matched digits to the PSTN?