Refer to the exhibit.

Which configuration is the correct Cisco IOS configuration that corresponds to the Cisco SAF Forwarder that is shown in the exhibit?

Refer to the exhibits.

End-to-end RSVP with local RSVP fallback has been configured on the HQ Cisco Unified Communications Manager. RSVP between the locations that are assigned to the IP phones and SIP trunk at the HQ site is configured as mandatory. When a call is placed from an HQ phone to a BR phone, the end-to-end RSVP request fails.

Refer to the SDI trace. Which statement about the call is true?

Refer to the exhibit

Which course of action will recieve the Mobile Connect issues that are shown in the exhibit?

All directory number extensions are assigned to the Internal _LP partition. All phones are configured with only a line CSS, BR1 Jntl.CSS. Assuming the gateway has been configured correctly. When the two PSTN callers place a call to 02288223002, which of the following statements is true?

Refer to the topolgy exhibit.

When the Cisco Unified Communications Manager at the BR1 site loses connectivity to the SAF network, the call to extension 3001 fails to reroute via the PSTN. Examine the SDI trace in the exhibit. What is the most likely cause of the failure?

Refer to the exhibit.

When Alice, at extension 2001, places a call to Bob, at extension 3001, Alice hears her own voice reflected. Which type of echo is this classified as?

Refer to the exhibit.

An intercluster call was placed from extension 2001 to 3001. The SDI trace from the calling cluster. Which RTP port was used by the calling phone?

Refer to the exhibit.

When an HQ caller places a call to extension 4001 the phone at BR2 rings. After the user at BR2 goes off hook, the call is disconnected. Examine the debug voice ccapi voice inout command output. What caused the issue?

Refer to the exhibit

When the IP phone 2001 places a call to 90114940302156001, the call is sent to the Cisco Untified Border Element 40302156001 which is what the ITSP expects to receive. The ITSP support personnel claim that they never saw the call, issuing the debug CCSIP message command on the Cisco Unified Border Elmement results in the message “SIP/2 404 Not Found”.

Refer to the Cisco Unified Border Element configuration, debug voice dial and ccsip message exhibits. Which situation can cause this issue?

Refer to the exhibits.

When a remote Cisco Unified Communications Manager learns the advertised patterns that are shown in the exhibit, which patterns would be shown in the Cisco Unified Communications Manager RTMT tool?