Which two capabilities of NetFlow accounting assist designers with network planning? (Choose two.)

Which two of the following statements represent a preferred wireless LWAPP implementation? (Choose two.)

You design a network with the following network addresses:

192.168.168.0

192.168.169.0

192.168.170.0

192.168.171.0

192.168.172.0

192.168.173.0

192.168.174.0

192.168.175.0

Which route address is the best summary of these network addresses?

Which statement accurately describes one difference between a small office and medium office topology?

Which three types of WAN topologies can be deployed in the Cisco Enterprise Architecture Enterprise Edge WAN module? (Choose three.)

Which two routing protocols operate over NBMA point-to-multipoint networks without the use of
point-to-point subinterfaces? (Choose two.)

A Cisco security mechanism has the following attributes:

it is a sensor appliance

it searches for potential attacks by capturing and analyzing traffic

it is a "purpose-built device"

it is installed passively

it introduces no delay or overhead

Which Cisco security mechanism is this?

A network design includes private addressing, but there is also a need for two or three network devices to each be assigned a unique public address so they can be accessed from the Internet.
Which technique will satisfy this requirement?

Lightweight access points are being deployed in remote locations where others are already operational. The new access points are in a separate IP subnet from the wireless controller. OTAP has not been enabled at any locations. Which two methods can the AP use to locate a wireless controller? (Choose two.)

Which statement identifies a benefit obtained when using a top-down network design plan?