which router, interface, and in what direction should the access list be placed to most efficiently implement
An access list has been designed to prevent Telnet traffic from the Graphics Department from reaching the HR server attached to the Eastfield router but allow Telnet traffic to other destinations. Given the following access list:
access-list 101 deny tcp any any eq 23
permit ip any any
On which router, interface, and in what direction should the access list be placed to most efficiently implement this list? (Choose three.)
Which command can be used from a router to verify the Layer 3 path to a host?
Which command can be used from a router to verify the Layer 3 path to a host?
what router ID will OSPF use for this router?
Refer to the exhibit.
Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?
Exhibit:
Which set of commands will accomplish this task?
A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the configuration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task?
which route will be placed in the IP routing table?
A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote network. If there are no static routes to the destination and none of the routes were redistributed, which route will be placed in the IP routing table?
What could be the cause of the problem?
Refer to the exhibit.
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts have been verified as correct. What could be the cause of the problem?
Exhibit:
What can be concluded from the output in the exhibit?
Refer to the exhibit.
The show interfaces serial 0/1 command was issued on the R10-1 router. What can be concluded from the output in the exhibit?
Exhibit:
How will the router handle a packet destined for 192.0.2.156?
Refer to the exhibit.
How will the router handle a packet destined for 192.0.2.156?
Exhibit:
How does using the service password-encryption command on a router provide additional security?
How does using the service password-encryption command on a router provide additional security?
how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?
Refer to the exhibit.
Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?
Exhibit: