Refer to the exhibit.

C-router is to be used as a “router-on-a-stick” to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What can be said about this configuration?

Exhibit:

Refer to the exhibit.

Given the partial configuration shown in the exhibit, why do internal workstations on the 192.168.1.0 network fail to access the Internet?

Exhibit:

A network administrator has configured access list 173 to prevent Telnet and ICMP traffic from reaching a server with the address of 192.168.13.26. Which commands can the administrator issue to verify that the access list is working properly? (Choose three.)

Which command displays the CHAP authentication process as it occurs between two routers?

What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?

A network engineer wants to allow a temporary entry for a remote user with a specific username and password so that the user can access the entire network over the Internet. Which ACL can be used?

Refer to the exhibit.

Router4 can ping Router5 (172.16.6.5), but not Router7 (172.16.11.7). There are no routing protocols running in any of the routers, and Router4 has Router6 as its default gateway. What can be done to address this problem?

Exhibit:

Refer to the exhibit.

A network technician enters the following lines into the router.

Tidmore1(config)# interface FastEthernet 0/0

Tidmore1(config-if)# no ip access-group 106 in

Tidmore1(config-if)# interface Serial 0/0

Tidmore1(config-if)# ip access-group 106 out

What is the effect of this configuration?

Exhibit:

Refer to the graphic.

A company wants to use NAT in the network shown. Which commands will apply the NAT configuration to the proper interfaces? (Choose two.)

What does the “Inside Global” address represent in the configuration of NAT?