DRAG DROP
Drag the description on the left to the correct router mode on right.

DRAG DROP
Drag the description on the left to the routing protocol on the right.

DRAG DROP
Complete the network topology shown in the graphic by dragging the labels below with the appropriate router types, interface types, and IP addresses to the graphic

DRAG DROP
Two offices are displayed below

You work as a network technician. Study the exhibit carefully. The company has a main office in
Los Angeles and a satellite office in Boston. The offices are connected through two Cisco routers.
The Boston satellite office is connected through the R2 router s0 interface to the Los Angeles
office R1 router s1 interface. R1 has two local area networks. Boston users receive Internet
access through the R1 router. Drag the boxes on the top to complete the goal on the left.

DRAG DROP
The left describes the types of cables, while the right describes the purposes of the cables.

Drag the items on the left to the proper locations. (Not all items can be used.)

DRAG DROP
You are configuring the office. In particular the host C, with the IP address 192.168.125.34/27,
needs to be configured so that it cannot access hosts outside its own subnet. You decide to use
the following command:
access-list 100 deny protocol address mask any
You are required to fill in the protocol, address, and mask in this command using the choices
below:

DRAG DROP
If a Cisco router has learned about network 10.1.1.0 from multiple sources, the router will select
and Install only one entry into the routing table. Indicate the order of preference that the router will
use by dragging the routes on the left to the — of preference category on the right.

DRAG DROP
The left describes some types of connections, while the right describes some types of cables.
Drag the items on the left to the proper locations.

DRAG DROP
The left provides some routing protocols, while the right gives several Cisco default administrator
distances. Drag the items on the right to the proper locations.

CORRECT TEXT
CP.Inc has decided to network three (3) locations to improve efficiency in inventory control. The
routers have been named to reflect the location: -RA, -RB, -RC. The necessary networking has
been completed at each location, and the routers have been configured with single area OSPF as
the routing protocol. The -RA router was recently installed but connectivity is not complete
because of incomplete routing tables. Identify and correct any problem you see in the
configuration.
NOTE: The OSPF process must be configured to allow interfaces in specific subnets to paricipate
in the routing process.