Refer to the topology.

If Sw-E is the root for all VLANs, which of the following is a valid path from host A to Server
1?

Refer to the topology.

What technology helps prevent frames from looping continuously through this switched
network?

Refer to the topology.

What, if anything, is required for communication to occur between the host C and Server 3?

Refer to the topology.

What type of link is needed between Sw-A and Sw-B so host C and host D can communicate
through Sw-A to the servers?

DRAG DROP
Drag each appropriate option on the left to its proper placeholder on the right.

DRAG DROP
Match the address list conditions on the left with the goals on the right.

DRAG DROP

Riverside Towing is redesigning the network that connects its three locations. The administrator
gave the networking team 192 168.45 0 to use for addressing the entire network. After subnetting
the address, the team is ready to assign the addresses. The administrator plans to configure ip
subnet-zero and use RIP v2 as the routing protocol. As a member of the networking team, you
must address the network and at the same time conserve unused addresses for future growth.
With those goals in mind, drag the host addresses on the left to the correct router interface. One of
the routers is partially configured. Move your mouse over a router to view its configuration. Not all
of the host addresses on the left are necessary.

DRAG DROP
Drag the addresses to fill in the NAT terminology table with their associated IP address values.

CORRECT TEXT
VTP Configuration LAB.
A new switch is being added to the River Campus LAN. You will work to complete this process by
first configuring the building_210 switch with an IP address and default gateway. For the switch
host address, you should use the last available IP address on the management subnet. In
addition, the switch needs to be configured to be in the same VTP domain as the building_100
switch and also needs to be configured as a VTP client. Assume that the IP configuration and VTP
configuration on building_100 are complete and correct.
The configuration of the router is not accessible for this exercise. You must accomplish the
following tasks:
Determine and configure the IP host address of the new switch.
Determine and configure the default gateway of the new switch.
Determine and configure the correct VTP domain name for the new switch.
Configure the new switch as a VTP client.

DRAG DROP
Drag each feature of the left to the appropriate routing protocol on the right.