Which of the following are true regarding the debug output shown in the graphic? (Choose Two)

Which two statements are characteristics of a distance vector routing protocol? (Choose two)

What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?

Which two statements describe the advantages to the use of RIP over the use of OSPF? (Choose two)

A medium-sized company has a Class C IP address. It has two Cisco routers and one non-Cisco router. All three routers are using RIP version 1. The company network is using the block of 198.133.219.0/24. The company has decided it would be a good idea to split the network into three smaller subnets and create the option of conserving addresses with VLSM. What is the best course of action if the company wants to have 40 hosts in each of the three subnets?

Refer to the graphic:

Host 1 cannot receive packets from Host 2. Assuming that RIP v1 is the routing protocol in use, what is wrong with the IP configuration information shown? (Choose two.)

Which routing protocols will support the following IP addressing scheme? (Choose three.)

Network 1 – 192.168.10.0 /26

Network 2 – 192.168.10.64 /27

Network 3 – 192.168.10.96 /27

Network 4 – 192.168.10.128 /30

Network 5 – 192.168.10.132 /30

Use the output from the router shown in the graphic above to determine which of the following are correct. (Choose two.)

Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure?

Which of the following commands will configure a default route to any destination network not found in the routing table?