A network administrator is configuring ACLs on a Cisco router
A network administrator is configuring ACLs on a Cisco router, to allow IP access form the 192.168.146.0/24,192.168.147.0/24,192.168.148.0/2,. and 192.168.149.0/24 networks only. Which two ACLs, when combined, should be used.
How will the default route configured on R1 affect the operation of R2?
You work as a network technician, study the exhibits carefully.
Configuration exhibit:
R1 routing commands:
ip route 0.0.0.0 0.0.0.0 serial0/0
router ospf 1
network 172.16.100.0 0.0.0.3 area 0
network 172.16.100.64 0.0.0.63 area 0
network 172.16.100.128 0.0.0.31 area 0
default-information originate
Assume that all router interfaces are operational and correctly configured. In addition, assume that OSPF has been correctly configured on router R2. How will the default route configured on R1 affect the operation of R2?
Why would the network administrator configure RA in this manner?
Refer to the exhibit.
Why would the network administrator configure RA in this manner?
Which command shows if 10.10.10.0/24 are allowed inside addresses?
Refer to the exhibit. Addresses within the range 10.10.10.0/24 are not being translated to the 1.128.0/16 range. Which command shows if 10.10.10.0/24 are allowed inside addresses?
What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet
Refer to the exhibit.
What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN? (Choose two.)
Which interfaces are access ports?
A network associate is trying to understand the operation of the FLD Corporation by studying the network in the exhibit. The associate knows that the server in VLAN 4 provides the necessary resources to support the user hosts in the other VLANs. The associate needs to determine which interfaces are access ports. Which interfaces are access ports? (Choose three.)
What can be determined about the router from the console output?
Refer to the exhibit. What can be determined about the router from the console output?
Which WAN protocol is being used?
Refer to the exhibit. Which WAN protocol is being used?
What type of connection would be supported by the cable diagram shown?
Refer to the exhibit. What type of connection would be supported by the cable diagram shown?
Pin Number
Color
Function
Color
Function
1
White/Green
TX+
1
White/Green
TX+
2
Green
TX-
2
Green
TX-
3
White/Orange
RX+
3
White/Orange
RX+
6
Orange
RX-
6
Orange
RX-
What is needed to allow communication between VLANs?
Refer to the exhibit.
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs.
What is needed to allow communication between VLANs?