What is the cause of the problem?
Refer to the exhibit.
The Frame Relay network in the diagram is not functioning properly.
What is the cause of the problem?
What is the correct subnet mask for this network?
Refer to the exhibit.
The router address 192.168.1.250 is the default gateway for both the Web Server 2 and Host 1.
What is the correct subnet mask for this network?
which two ways will the routers in this network respond to this change?
Refer to the exhibit.
The network shown in the exhibit is running the RIPv2 routing protocol. The network has converged, and the routers in this network are functionning properly.
The FastEthernet0/0 interface on R1 goes down. in which two ways will the routers in this network respond to this change? (choose two)
what will Host1 do?
The use of Host1 wants to ping the DSL modem/router at 192.168.1.254.
Based on the Host1 ARP table that is shown in the exhibit, what will Host1 do?
Which partial routing table entry in the Central router representsa router summary that represents the LANs in
Refer to the exhibit.
The lakeside Compnay has the internetwork in the exhibit. The administrator would like to reduce the size of the routing table on the Central router. Which partial routing table entry in the Central router representsa router summary that represents the LANs in Pheonix but no additional subnets?
What route could be configured on router R1 for file requests to reach the server?
Refer to the exhibit.
Users on the 192.168.1.0/24 network must access files located on the Server1.
What route could be configured on router R1 for file requests to reach the server?
Which set of command is required to accomplish this task?
Refer to the exhibit.
A technician has installed SwitchB and needs to configure it for remote access from the management workstation connected to SwitchA.
Which set of command is required to accomplish this task?
Which of the following could cause this problem?
Refer to the exhibit.
Computer 1 is consoles into switch A. Telnet connections and pings run from the command prompt on switch A fail.
Which of the following could cause this problem?
what is the most likely cause of the problem?
Refer to the exhibit.
Router A is unable to reach Router B. Both routers are running IOS version 12.0. After reviewing the command output and graphic, what is the most likely cause of the problem?
what is the problem?
Refer to the exhibit.
A host is connected to switch port Fa0/3 with a crossover cable. The host and switch have as shown.
However, the port indicator on switch port Fa0/3 is not on, and the host can not communicate with to vlan 2 on the same switch. Based on the information given. what is the problem?