Which command would allow the translations to be created on the router?
Refer to the exhibit:
Which command would allow the translations to be created on the router?
Which command shows if 10.10.10.0/24 are allowed inside addresses?
Refer to the exhibit:
Addresses within the range 10.10.10.0/24 are not being translated to the 1.128.0/16 range. Which command shows if 10.10.10.0/24 are allowed inside addresses?
What are the two results of this configuration?
Refer to the exhibit. The router has been configured with these commands:
hostname Gateway
interface FastEthernet 0/0
ip address 198.133.219.14 255.255.255.248
no shutdown
interface FastEthernet 0/1
ip address 192.168.10.254 255.255.255.0
no shutdown
interface Serial 0/0
ip address 64.100.0.2 255.255.255.252
no shutdown
ip route 0.0.0.0 0.0.0.0 64.100.0.1
What are the two results of this configuration? (Choose two.)
What would be the effect of issuing the command access-group 115 in on the s0/0/1 interface?
What would be the effect of issuing the command access-group 115 in on the s0/0/1 interface?
ACL (exhibit):
show running-config (exhibit):
show running-config 2 (exhibit):
show running-config 3 (exhibit):
Which will fix the issue and allow ONLY ping to work while keeping telnet disabled?
Which will fix the issue and allow ONLY ping to work while keeping telnet disabled?
ACL (exhibit):
show running-config (exhibit):
show running-config 2 (exhibit):
show running-config 3 (exhibit):
Which wild card mask and address combination will only match addresses on this network?
The exhibit shows a company network. The network administrator would like to permit only hosts on the 172.30.16.0/24 network to access the Internet. Which wild card mask and address combination will only match addresses on this network?
Why would the network administrator configure RA in this manner?
Refer to the exhibit:
Why would the network administrator configure RA in this manner?
What can be said about this configuration?
Refer to the exhibit:
C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What can be said about this configuration?
What is needed to allow communication between VLANs?
Refer to the exhibit:
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs?
What should the network administrator do?
Refer to the exhibit:
The switches have been configured with static VLANs as shown. During testing, the network administrator notices that VLAN 20 on SwitchA has no connectivity with VLAN 30 on SwitchB. What should the network administrator do?