What two things will a router do when running a distance vector routing protocol?
What two things will a router do when running a distance vector routing protocol? (Choose two.)
Which command allows you to see output from the OSPF debug command?
Refer to the exhibit. You are connected to the router as user Mike. Which command allows you to see output from the OSPF debug command?
Which command shows if an access list is assigned to an interface?
Which command shows if an access list is assigned to an interface?
Which two destination addresses will host 4 use to send data to host 1?
Both switches are using a default configuration. Which two destination addresses will host 4 use to send data to host 1? (Choose two.) A. the IP address of host 1 B. the IP address of host 4 C. the MAC address of host 1 D. the MAC address of host 4 E. the MAC address […]
What could be possible causes for the "Serial0/0 is down" interface status?
What could be possible causes for the “Serial0/0 is down” interface status? (Choose two.) A. A Layer 1 problem exists. B. The bandwidth is set too low. C. A protocol mismatch exists. D. An incorrect cable is being used. E. There is an incorrect IP address on the Serial 0/0 interface.
Which command should be used to create this map?
A static map to the S-AMER location is required. Which command should be used to create this map?
Exhibit:
What does STATUS=ACTIVE refer to in the output of the show frame-relay pvc command?
Refer to the exhibit:
What does STATUS=ACTIVE refer to in the output of the show frame-relay pvc command?
What destination Layer 2 address will be used in the frame header containing a packet for host 172.30.4.4Exhib
What destination Layer 2 address will be used in the frame header containing a packet for host 172.30.4.4
Exhibit:
Which connection uses the default encapsulation for serial interfaces on Cisco routers?
Which connection uses the default encapsulation for serial interfaces on Cisco routers?
Exhibit:
what password should be configured on the router in the MidEast branch office to allow a connection to be esta
If required, what password should be configured on the router in the MidEast branch office to allow a connection to be established with the Dubai router?
show frame-relay map (exhibit):
show running-config (exhibit):