What is the purpose of a default route?

Refer to the exhibit. What does STATUS=ACTIVE refer to in the output of the show frame-relay
pvc command?

IP addresses and routing for the network are configured as shown in the exhibit. The network
administrator issues the show ip eigrp neighbors command from Router1 and receives the output
shown below the topology. Which statement is true?

Refer to the topology and configuration information shown in the graphic. The router has been
configured to provide communication between the VLANs. Which IOS commands are required to
configure switch port fa0/1 to establish a link with router R1 using the IEEE standard protocol?
(Choose three.)

Which of the following statements describe the network shown in the graphic? (Choose two.)

Refer to the exhibit. The switches have been configured with static VLANs as shown. During
testing, the network administrator notices that VLAN 20 on SwitchA has no connectivity with VLAN
30 on SwitchB. What should the network administrator do?

Which of the following host addresses are members of networks that can be routed across the
public Internet? (Choose three.)

The system LED is amber on a Cisco Catalyst 2950 series switch. What does this indicate?

An access list was written with the four statements shown in the graphic. Which single access list
statement will combine all four of these statements into a single statement that will have exactly
the same effect?

DRAG DROP
From the partial router output below, match the output information to the IOS layer.