what configuration command line?
To enable SONET payload scrambling on a POS interface, use what configuration command line?
What is the worst case optical signal-to-noise ratio (OSNR) of Channel 1 at 0.5nm away from the peak?
Click the Exhibit button to view the graph.
The graph represents optical signal power versus wavelength measurement from 1550nm to 1560nm. What is the worst case optical signal-to-noise ratio (OSNR) of Channel 1 at 0.5nm away from the peak?
What is the destination MAC address of the packet on Host’s 1 Ethernet?
Click the Exhibit button to view the topology.
Host 1 and Host 2 are on Ethernet LANs in different buildings. A serial line is installed between two Cisco routers using Cisco HDLC serial line encapsulation. Routers A and B are configured to route IP traffic. Host 1 sends a packet to Host 2. What is the destination MAC address of the packet on Host’s 1 Ethernet?
which OSPF configurations listed are valid?
Click the Exhibit button to view the topology.
Based on the information above, which OSPF configurations listed are valid? (multiple answer)
What wavelength window does a C-Band amplifier use?
What wavelength window does a C-Band amplifier use?
What is the purpose of automatic gain control (AGC) in EDFA?
What is the purpose of automatic gain control (AGC) in EDFA?
What tool holds settings for GateWay/SNMP, GateWay/TL1 and GateWay/CORBA?
What tool holds settings for GateWay/SNMP, GateWay/TL1 and GateWay/CORBA?
which one of the routes would forward a packet destined for 10.1.1.1?
Click the Exhibit button to view the routing table. If a router had the three routes listed, which one of the routes would forward a packet destined for 10.1.1.1?
Which byte is tagged on the STM-1 signal to carry out this function?
In SDH the origin of a signal is an important factor in isolating trouble spots. Which byte is tagged on the STM-1 signal to carry out this function?
which node would you install it?
Click the Exhibit button.
In the figure, what IP address would you assign to a desktop connected to the TCC port on node E.Would a static route be needed to allow access to other nodes, and in which node would you install it?
