Which statement best describes implementing a Layer 3 EtherChannel?

What benefit results from implementation of Layer 3 switching versus Layer 2 switching in a
fully meshed campus network?

When configuring a routed port on a Cisco multilayer switch, which of these is a required
configuration task that you must perform to enable that port to function as a routed port?

What is true of standard access control lists when applied to an interface to control inbound
or outbound traffic?

You have configured a Cisco Catalyst switch to perform Layer 3 routing via an SVI and have
assigned that interface to VLAN 20. To check the status of the SVI, you issue the show
interfaces vlan 20 command at the CLI prompt. You see from the output display that the
interface is in an “up/up” state. What must be true in an SVI configuration to bring the VLAN
and line protocol up?

Refer to the exhibit.

You have configured an interface to be an SVI for Layer 3 routing
capabilities. Assuming that all VLANs have been correctly configured and based on the
configuration example shown, what can be determined?

A new building has been added to the enterprise campus network, providing client access
for desktop PCs, laptops, and IP phones for employees and guests. During verification, only
a few laptops using wireless are reported to have problems, while other desktops, IP
phones, and most other wireless laptops are fully operational. Additional information
received about the problem indicates that, while the problematic wireless laptops cannot
reach internal corporate websites, they can reach the Internet. Where should troubleshooting
about this connectivity issue be focused?

A new floor has been added to the enterprise campus network, providing client access for
desktop PCs, laptops, and IP phones for employees and guests. During verification, a few
desktop PCs have limited corporate access but not Internet access. Most other desktop
PCs, all laptops, and IP phones are working correctly. Additional information indicates that
the desktop PCs are obtaining IP host addresses from the DHCP server, which is intended
for only the IP phones. Where should troubleshooting about this connectivity issue be focused?

Refer to the exhibit.

From the configuration sample shown of a Cisco Catalyst 3560 Series
Switch, what can you determine regarding Layer 3 routing functionality of the interface?

Refer to the exhibit.

Based on the configuration shown, which two statements are correct
regarding this Layer 3 security configuration example? (Choose two.)