Which of the following could be used to provide a Layer 3 data path between separate
VLANs? (Choose two.)

You are configuring a Cisco multilayer switch for the Company network. Which command
would you use to configure a port to act as a routed interface?

Refer to the exhibit. PCs in VLAN 2 are not able to communicate with PCs in VLAN 3. What
could be the cause?

The Company security administrator is concerned with VLAN hopping based attacks. Which
two statements about these attacks are true? (Select two)

The Company security administrator wants to prevent VLAN hopping on the network. What
is one method that can be used to do this?

A hacker on the Company network is attempting to hop onto a different VLAN. Which two
statements about VLAN hopping are true? (Choose two)

Refer to the exhibit. What will happen to traffic within VLAN 14 with a source address of
172.16.10.5?

Refer to the exhibit. Dynamic ARP inspection (DAI) is enabled on switch SW_A only. Both
Host_A and Host_B acquire their IP addresses from the DHCP server connected to switch
SW_

Refer to the exhibit. Host A and Host B are connected to the Catalyst 3550 switch and have
been assigned to their respective VLANs. The rest of the 3550 configuration is the default
configuration. Host A is able to ping its default gateway, 10.10.10.1, but is unable to ping
Host B. Given the output displayed in the exhibit, which statement is true?

Refer to the exhibit. VLAN2, VLAN3, and VLAN10 are configured on the switch D-SW1. Host
computers are on VLAN 2 (10.1.2.0), servers are on VLAN 3 (10.1.3.0), and the
management VLAN is on VLAN10 (10.1.10.0). Hosts are able to ping each other but are
unable to reach the servers. On the basis of the exhibited output, which configuration
solution could rectify the problem?