The ABC Company network is running EIGRP on the T1 links within their NBMA frame relay
network. By default what would the hold time be for hello packets across these WAN links?

EIGRP is being used as the routing protocol within the ABC Company network. Which two of
the following features allow EIGRP to support classless routing? (Select two)

The ABC Company network administrator has issued the “EIGRP stub” command on router
PG8. What is the purpose of the “EIGRP stub” configuration command?

You need to configure EIGRP on a new ABC Company router. Which command should you
issue first to configure EIGRP for IP?

You need to configure route summarization on a ABC Company EIGRP router. Which is the
correct command format to configure EIGRP summary route?

You want to enable load sharing across the ABC Company WAN using EIGRP. Which
configuration command is used to enable EIGRP unequal-cost path load balancing?

You are a network administrator on a Cisco router that’s running EIGRP. You want to
aggregate some of the routes. Which of the following commands below would you enter to
configure the summary route you need?

Router PG1 has a 256kbps serial interface link to another ABC Company location. The
configuration file of this interface is shown below:
interface serial 0/0
bandwidth 56
ip bandwidth-percent eigrp 1 200
From the command output above, how many kbps of bandwidth is allocated for EIGRP
traffic?

EIGRP is being used as the routing protocol on the ABC Company network. While
troubleshooting some network connectivity issues, you notice a large number of EIGRP SIA
(Stuck in Active) messages. What causes these SIA routes? (Select two)

A ABC Company network administrator is troubleshooting an EIGRP configuration across a
discontiguous network. What must the administrator do to ensure all of the ABC Company
routers have the correct routing information?