Which of the following are true of both OSPFv2 and OSPFv3?
Which of the following are true of both OSPFv2 and OSPFv3? (Choose two.)
which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration
exists in a planning document, intended to be used to copy/paste into
Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration
exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about
OSPFv3 on R1 after this configuration has been pasted into R1?
ipv6 router ospf 1
ipv6 unicast-routing
interface f0/0
ipv6 address 2000::1/64
ipv6 ospf 1 area 1
interface s0/0/0
ipv6 address 2001::/64 eui-64
ipv6 ospf 1 area 0
Which of the following should be true of redistribution in this case?
The following output occurs on Router R1, which runs both EIGRP for IPv6 and OSPFv3,
with redistribution from EIGRP into OSPF configured with the redistribute eigrp 1 metric 25
command. Interface S0/0/1 has been enabled for EIGRP ASN 1. Which of the following
should be true of redistribution in this case?
D 2000::/64 [90/1422516]
via FE80::213:19FF:FE7B:5026, Serial0/0/1
C 2000:0:0:1::/64 [0/0]
via Serial0/0/1, directly connected
L 2000::1:213:19FF:FE7B:5004/128 [0/0]
via Serial0/0/1, receive
Which of the following does the 64 at the end of the command represent?
Router R1 has been configured with an ipv6 route 2000::/64 S0/0/0 64 command.
Which of the following does the 64 at the end of the command represent?
Which of the following tools would be most appropriate?
An enterprise has plans to start adding IPv6 support. For the first year, the IPv6 will be in
small pockets spread around the existing large IPv4 network, with occasional IPv6 traffic
while applications teams test IPv6-enabled servers and applications. Which of the following
tools would be most appropriate?
Which of the following tools would be most appropriate?
An enterprise has plans to start adding IPv6 support. The initial deployment requires support
from some IPv6-only devices that need to access servers that support only IPv4. Which of
the following tools would be most appropriate?
Which of the following IPv6 coexistence features is likely at work on the host?
A client host uses IPv4 to communicate with one server and IPv6 to communicate with
another. Which of the following IPv6 coexistence features is likely at work on the host?
Which type of tunnel is created by this configuration?
The following configuration exists on a router on one end of an IPv6 tunnel. Which type of
tunnel is created by this configuration?
interface loopback 1
ip address 1.1.1.1 255.255.255.255
interface tunnel 2
ipv6 address 2000::1::/64
tunnel source loopback 1
tunnel destination 2.2.2.2
tunnel mode ipv6ip
ipv6 eigrp 1
Which of the following commands is not required for the configuration to pass IPv6 traffic?
An engineer is reviewing another engineer’s sample configuration for a GRE tunnel used to
pass IPv6 traffiC. The tunnel has not yet been configured on the router. Which of the
following commands is not required for the configuration to pass IPv6 traffic?
Which of the following IPv6 tunneling mechanisms support IPv6 IGP routing protocols?
Which of the following IPv6 tunneling mechanisms support IPv6 IGP routing protocols?
(Choose two.)