Which functions do the two commands serve in this scenario?
A network engineer is asked to configure a “site-to-site” IPsec VPN tunnel. One of the last things
that the engineer does is to configure an access list (access-list 1 permit any) along with the
command ip nat inside source list 1 int s0/0 overload. Which functions do the two commands
serve in this scenario?
Which action will allow for manual switching of HSRP nodes?
A network engineer is configuring a solution to allow failover of HSRP nodes during maintenance
windows, as an alternative to powering down the active router and letting the network respond
accordingly. Which action will allow for manual switching of HSRP nodes?
Which feature should the engineer use to gather the required information?
A network engineer is notified that several employees are experiencing network performance
related issues, and bandwidth-intensive applications are identified as the root cause. In order to
identify which specific type of traffic is causing this slowness, information such as the
source/destination IP and Layer 4 port numbers is required. Which feature should the engineer
use to gather the required information?
What can you determine based on this information?
An organization decides to implement NetFlow on its network to monitor the fluctuation of traffic
that is disrupting core services. After reviewing the output of NetFlow, the network engineer is
unable to see OUT traffic on the interfaces. What can you determine based on this information?
What is the expected output?
A network engineer has left a NetFlow capture enabled over the weekend to gather information
regarding excessive bandwidth utilization. The following command is entered:
switch#show flow exporter Flow_Exporter-1
What is the expected output?
What is the best solution to ensure compliance with this new policy?
A company’s corporate policy has been updated to require that stateless, 1-to-1, and IPv6 to IPv6
translations at the Internet edge are performed. What is the best solution to ensure compliance
with this new policy?
Which two functions are completely independent when implementing NAT64 over NAT-PT?
Which two functions are completely independent when implementing NAT64 over NAT-PT?
(Choose two.)
Which two methods of deployment can you use when implementing NAT64?
Which two methods of deployment can you use when implementing NAT64? (Choose two.)
Which NetFlow component is applied to an interface and collects information about flows?
Which NetFlow component is applied to an interface and collects information about flows?