A router with an interface that is configured with ipv6 address autoconfig also has a link-local
address assigned. Which message is required to obtain a global unicast address when a router is
present?

An engineer has configured a router to use EUI-64, and was asked to document the IPv6 address
of the router. The router has the following interface parameters:
mac address C601.420F.0007
subnet 2001:DB8:0:1::/64
Which IPv6 addresses should the engineer add to the documentation?

For security purposes, an IPv6 traffic filter was configured under various interfaces on the local
router. However, shortly after implementing the traffic filter, OSPFv3 neighbor adjacencies were
lost. What caused this issue?

What is the purpose of the autonomous-system {autonomous-system-number} command?

What is the default OSPF hello interval on a Frame Relay point-to-point network?

Refer to the exhibit.

Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?

Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?

Router A and Router B are configured with IPv6 addressing and basic routing capabilities using
OSPFv3. The networks that are advertised from Router A do not show up in Router B’s routing
table. After debugging IPv6 packets, the message “not a router” is found in the output. Why is the
routing information not being learned by Router B?

After you review the output of the command show ipv6 interface brief, you see that several IPv6
addresses have the 16-bit hexadecimal value of “FFFE” inserted into the address. Based on this
information, what do you conclude about these IPv6 addresses?

A packet capture log indicates that several router solicitation messages were sent from a local
host on the IPv6 segment. What is the expected acknowledgment and its usage?