An outside host has established an SSH connection with an inside host. Both hosts have sent and received
data over the SSH session.
Which of the following lines of output from the show conn command best represents the state of the connection
in this scenario? (Select the best answer.)

Which of the following facilitates the use of one authentication framework for connecting to both wired and
wireless devices on a Cisco Unified Wireless Network? (Select the best answer.)

Which of the following commands should you issue to allow communication between different ASA interfaces
that share the same security level? (Select the best answer.)

Which of the following security applications is least likely to be included in a vendor’s desktop security suite?
(Select the best answer.)

Which of the following vulnerabilities did the Stuxnet worm exploit on target hosts? (Select 2 choices.)

You issue the following commands on a Cisco ASA. No other interfaces have been configured.
asa(config)#interface gigabitethernet 0/1asa(configif)#speed 1000
asa(configif)#duplex full
asa(configif)#securitylevel 0
asa(configif)#nameif inside
asa(configif)#ip address 10.1.1.1
255.255.255.0 asa(configif)#no
shutdownasa(configif)#exit
asa(config)#telnet 10.1.1.0 255.255.255.0
inside asa(config)#telnet timeout 30
Which of the following statements is true regarding the resulting configuration? (Select the best answer.)

You have configured antispoofing ACLs and DHCP snooping.
Which of the following are you most likely securing? (Select the best answer.)

Which of the following authentication methods were invented by Cisco? (Select 2 choices.)

Your supervisor asks you to configure a local CA to help secure digital communications.
Which of the following best describes what your company is most likely implementing? (Select the best
answer.)

You have issued the following commands to modify the 802.1X configuration on a switch port:
switch(configif)#authentication event fail action next-method
switch(configif)#authentication order mab dot1x
switch(configif)#authentication priority dot1x mab
switch(configif)#authentication event noresponse action authorize
vlan 1313
A new host is attached to the switch port. The host’s MAC address is not in the authentication database. In
addition, the host does not support 802.1X.
Which of the following statements is true regarding the host in this scenario? (Select the best answer.)