Refer to the exhibit.

An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which
OSI layer is the problem?

Refer to the exhibit.

The two connected ports on the switch are not turning orange or green. What would be the most
effective steps to troubleshoot this physical layer problem? (Choose three.)

Refer to the exhibit.

The network shown in the diagram is experiencing connectivity problems. Which of the following
will correct the problems? (Choose two.)

Refer to the exhibit.

A problem with network connectivity has been observed. It is suspected that the cable connected
to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being
disconnected?

Refer to the exhibit.

HostA cannot ping HostB. Assuming routing is properly configured, what is the cause of this problem?

Which router IOS commands can be used to troubleshoot LAN connectivity problems? (Choose three.)

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The
routers cannot establish an adjacency relationship on their common Ethernet link.

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?

In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a
switched LAN?

Which will fix the issue and allow ONLY ping to work while keeping telnet disabled?

What would be the effect of issuing the command ip access-group 114 in to the fa0/0 interface?