Which type of EIGRP route entry describes a feasible successor?

The network administrator cannot connect to Switch1 over a Telnet session, although the hosts
attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic
and assuming that the router and Switch2 are configured properly, which of the following
commands should be issued on Switch1 to correct this problem?

Refer to the exhibit.

Which of these statements correctly describes the state of the switch once the boot process has
been completed?

Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but
they are unable to communicate. The Atlanta router is known to have the correct configuration.

Given the partial configurations, identify the fault on the Brevard router that is causing the lack of connectivity.

Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The
network administrator connected to router Coffee via the console port, issued the show ip route
command, and was able to ping the server.

Based on the output of the show ip route command and the topology shown in the graphic, what is
the cause of the failure?

A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing
this problem?

Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0

Which statement is correct regarding the operation of DHCP?

Refer to the exhibit.

What statement is true of the configuration for this network?

Which statement describes the process of dynamically assigning IP addresses by the DHCP
server?

What are two benefits of using NAT? (Choose two.)