Which two are advantages of static routing when compared to dynamic routing?
Which two are advantages of static routing when compared to dynamic routing? (Choose two.)
Which command enables IPv6 forwarding on a Cisco router?
Which command enables IPv6 forwarding on a Cisco router?
which route will be placed in the IP routing table?
A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default
characteristics. Each process learns a route to the same remote network. If there are no static
routes to the destination and none of the routes were redistributed, which route will be placed in
the IP routing table?
what router ID will OSPF use for this router?
Which routers are likely to have been elected as DR?
The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the
graphic. There is concern that a lack of router resources is impeding internetwork performance. As
part of examining the router resources, the OSPF DRs need to be known. All the router OSPF
priorities are at the default and the router IDs are shown with each router.
Which routers are likely to have been elected as DR? (Choose two.)
What does a router do if it has no EIGRP feasible successor route to a destination network and the successor r
What does a router do if it has no EIGRP feasible successor route to a destination network and
the successor route to that destination network is in active status?
what information will Router_E contain in its routing table for the subnets 208.149.23.64 and 208.149.23.96?
Which command is used to display the collection of OSPF link states?
Which command is used to display the collection of OSPF link states?
What is the default administrative distance of OSPF?
What is the default administrative distance of OSPF?
What is the result of the above configuration being applied to the switch?
The following configuration is applied to a Layer 2 Switch:
interface fastethernet 0/4
switchport mode access
switchport port-security
switchport port-security mac-address 0000.1111.1111
switchport port-security maximum 2
swithcport port-security
What is the result of the above configuration being applied to the switch?