Which two statements are true regarding ICMP packets? (Choose two.)

Which network topology allows all traffic to flow through a central hub?

Refer to the exhibit.

The MAC address table is shown in its entirety. The Ethernet frame that is shown arrives at the switch. What two operations will the switch perform when it receives
this frame? (Choose two.)

What is one requirement for interfaces to run IPv6?

Refer to the exhibit.

Which command is simplest to configure routing between the regional office network 10.89.0.0/20 and the corporate network?

Which entity assigns IPv6 addresses to end users?

Which device allows users to connect to the network using a single or double radio?

When a router makes a routing decision for a packet that is received from one network and destined to another, which portion of the packet does it replace?

What is the default lease time for a DHCP binding?

Instructions
For both the Router and the Switch the simulated console mode needs to start and remain in enabled mode.
RouterA and SwitchA have been configured to operate in a private network which will connect to the Internet. You have been asked to review the configuration prior
to cabling and implementation.
This task requires the use of various IOS commands to access and inspect the running configuration of RouterA and SwitchA. No configuration changes are
necessary.
You will connect to RouterA and SwilchA via the console devices that are attached to each.
There are 4 multiple-choice questions with this task. Be sure to answer all of them before leaving this item. In order to score the maximum points you will need to
have accessed both SwitchA and RouterA.
NOTE: The configuration command has been disabled for both the router and switch in this simulation.

Which two of the following are true regarding the configuration of RouterA? (Choose two.)